Peach Wine Recipe
From Distillers Wiki
STEP 1 INGREDIENTS
- 15 lbs peaches
- 5 gallons of water
- 8 lbs white granulated sugar
- 1 level teaspoon yeast energizer
- 6 level teaspoons acid blend
- 2 level teaspoons grape tannin
- 1 level teaspoon pectic enzyme
- 5 Campden tablets
STEP 2 INGREDIENTS
STEP 3 INGREDIENTS
STEP 5 INGREDIENTS
STEP 7 INGREDIENTS
1. Use only ripe fruit. Remove the stones and discard any rotten fruit. Crush the fruit, finely chop the fruit or run it through a food processor (do not process into a fine pulp). Put all step 1 ingredients in an open fermenter and stir well.
2. Use a hydrometer and adjust the sugar to 22 Brix by adding sugar in small quantities and stirring well. Use an acid test kit and adjust the acid to 0.65 percent by adding small quantities of acid crystals and stirring well. If a hydrometer or an acid test kit is not available, use the amounts shown in steps 1 and 2, but the quality of the wine will suffer.
3. Open the packet of dry yeast and sprinkle it on top of the must. Cover the fermenter, in 20 to 40 hours fermentation should start (bubbles form around the edge of the container).
5. When the hydrometer reads 12 to 14-Brix, strain out and discard the solids and siphon the liquid into a closed fermenter. Attach a fermentation lock filled half full of plain water. Always keep the container full of wine and always keep the fermentation lock half full of clean water.
6. After three weeks, rack the wine into a clean, closed container and add 5 crushed Campden tablets.
8. In a month or so, when the wine is clear and stable, add 3 Campden tablets. Add the sweetening sugar (to taste) and 2 level teaspoons (5 grams) of fresh potassium sorbate. Finally, bottle the wine.
VARIATION- Try using brown sugar instead of white sugar. Make a 5 gallon batch of each, notice the color, smell, and fermentation differences in both. Then write a small review, and post it here. I personally love the brown sugar method.
From a book The Home Wine Makers Manual BY Lum Eisenman